International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395-0056 Volume: 05 Issue: 09 | Sep 2018 p-ISSN: 2395-0072 Use of Saw Dust as Fine Aggregate in Concrete Mixture Mr. Tilak L.N1, Mr. Santhosh Kumar M.B1, Mr. Manvendra Singh2, Mr. Niranjan3 1Assistant Professor, Dept. of Civil Engineering, JSS Academy of Technical Education Noida., up, India.
Get MoreMaterials used in this study are; ordinary Portland cement, aggregate (fine of 4.75 mm size and coarse aggregate of size 20mm), sawdust generated from the mechanical processing of raw wood from saw mill industries in Akure, Nigeria which sieved with sieve aperture 425 without pretreatment. It was sun dried, sieved and then kept in waterproof bags.
Get MoreThe cost of construction has been on the increase which has become a concern to both individuals and government of especially developing countries, and that is why this study is aimed at using available cheap materials (sawdust) in concrete production. Concrete mix ratio of 1:2:4 was used and replaced with fine aggregate at 5%, 10%, 15% and 20% with soligum treated sawdust.
Get Moreat 10% sawdust replacement, production costs and weight reduced by 3% and 10% respectively. Usman et al (2012) found out that the strength of concrete reduced with sawdust as fine aggregate due to its higher rate of water absorption and the optimum replacement was 25%. Olutoge (2010) investigated the suitability of palm kernel shells and 1349 ...
Get MoreExperimental Research of Saw Dust as Partial Replacement for Fine Aggregate in Production .. 2 partial replacement for fine aggregate will contribute more to the quality and strength of the sandcrete blocks. [15] States thatsawdust is one of the natural fiber that is used as filler. Sawdusts are collection of fine particle of hard and soft woods.
Get MoreThe study determined the strength of concrete mixture with sand and concrete mixture with sawdust in three different curing periods; 7 days, 16 days and 28 days. Experimental method was used by the researchers for it examined and investigated the possibility of using sawdust as a fine aggregate in concrete mixture with both mixtures categorized ...
Get Morereplacement of cement with silica powder and fine aggregate with saw dust ash. In this ex per-iment natural sand was partially replaced (5%, 10%, and 15%) with SDA. Compressive .
Get MoreThe use of sawdust in concrete has received some interest over the past years. It was noted that, both the density and compressive strength of concrete decreased as the percentage replacement of fine aggregate by saw dust increased [29, 31].
Get Moreconcrete and to find the saw dust content required to attain maximum compressive strength. Adding saw dust to the mix by partially replacing fine aggregate to cast concrete specimens. The saw dust have to add by 10, 20 & 30 percentage of weight of the fine aggregates to compare with conventional concrete.
Get MoreFine aggregates are essentially any natural sand particles won from the land through the mining process. Fine aggregates consist of natural sand or any crushed stone particles that are ¼" or smaller.This product is often referred to as 1/4'" minus as it refers to …
Get MoreThe use of saw dust ash as fine aggregate replacement in concrete ... increase in strength and durability properties of plain concrete by inclusion of WFS as a partial replacement of fine aggregate.
Get MoreAbstract. This experimental study is aimed to create a concrete mixture consisting of sawdust which replaces the fine aggregate. It is also used to analyze the effect of sawdust concrete in terms ...
Get Moreon the effect of replacing fine aggregate with sawdust on the properties of concrete. A concrete mix of 1:1.5:3 is used while sawdust was used to replace 10%, 20%, 50% and of sand by volume. The percentage reduction in density is 4.02%, 5.54%, 9.15% and 19.20% respectively while the ...
Get More20% with the fine aggregate, a matured fine aggregate has prepared. Vignesh b, Lingaraju D (Dec ). "Experimental study on partial replacement of quarry dust and saw dust in fine aggregate". In this research was experimentally carried out to investigate properties of both sawdust and quarry dust when used as partial replacement in brick. 4.
Get MoreUse of Saw Dust as Fine Aggregate in Concrete Mixture. Fine aggregate = 1.3×5.7664 = 7.495 kg Saw dust = 1.3×201.2 = 261 gm Density Standard concrete density:- Mass of concrete = 8.43 kg Size of concrete block = 15cm×15cm×15cm Volume of concrete = 3375 cm Density = mass÷volume = 2497.77 kg/m 20% replacement of fine aggregate:- Mass of concrete = 7.938 kg
Get More1. To hold out the literature review for comprehensive study on partial replacement of sand by saw dirt as fine aggregate in concrete mixture. 2. To mix saw dust sample with sand in 10%, 20%, 30% and 40% and record the detail observations to check efficient percentage of the saw-dust that can be replaced by sand in the construction field. 3.
Get MoreThe study was an experimental study on hollow concrete blocks in a partial replacement of fine aggregate with sawdust in different proportion. The amount and kind of cement was constant, but the quantity of sawdust, aggregate and water was varied. The study was conducted in different steps.
Get MoreThe reduction in strength of concrete with sawdust as fine aggregate was due to its higher rate of water absorption because the higher the water contents in concrete, the lower the strength of the concrete. Optimum replacement of both sawdust and palmkernel shell with sand and granite was found to be 25% Journal of Chemical, Mechanical and ...
Get More(PDF) IRJET Use of Saw Dust as Fine Aggregate . INTRODUCTION industrial wastes to useful building and construction Concrete is a mixture of cement, fine and coarse aggregates materials Sawdust is an industrial waste, byproduct of and water, which are mixed in a specific proportion to get a cutting, grinding, drilling, sanding, or otherwise pulverizing particular strength
Get MoreThe properties of saw dust are shown in Table-3. It shows the density of light weight aggregate and will reduce the overall density of concrete. The thermal properties and fire resistance will be very less as sawdust used in the concrete. ii. Robosand Robosand or …
Get MoreThis experimental study aimed to develop an acceptable concrete mixture with sawdust particles as substitute to fine aggregate that can be used for building construction particularly in residential class concrete slab and analyze the effect of sawdust concrete mixture in terms of adhesion of aggregates, thermal insulation, workability and surface quality.
Get Morepercentage replacement and 10% Sawdust Ash in fine aggregate. Investigations were carried out in concrete mixtures with 5 levels of SGP (Sheet Glass Powder) replacement ranging from 10% to 50% and 10% Sawdust ash. The specimens were cast and tested to study the possibility of using SGP and SDA as a substitute material ...
Get MoreSaw dust was collected from the local wood factory. Coarser saw dust particles were removed by sieving through 4.75 mm sieve. Physical properties of coarse aggregate, river sand and saw dust were determined according to BIS 2386 (Part 3):1988 and are presented in Table 1.
Get Moreadvantages that sawdust concrete offers are considerable reduction in weight of the structure, thereby reducing the dead loads transmitted to the foundation, high economy when compared to normal weight concrete. Partially replaced sawdust with sand in proportion used as fine aggregates in concrete and
Get Morehence, the saw dust ash and coal dust as fine aggregate decreases the value for modulus of elasticity; 5) The use of saw dust ash and coal dust as an alternative fine aggregate decreases the amount of material cost for concrete due to replaced aggregate.; 6) There is a …
Get MoreTo overcome the stress and demand for natural fine aggregate and cement, researchers and practitioners in the construction industries have identified some alternative materials such as fly ash, slag, limestone-powder, siliceous materials, saw dust ash.
Get More-- Created using Powtoon -- Free sign up at -- Create animated videos and animated presentations for free. PowToon is a free...
Get MoreThis study examined the use of the locally available building materials such as sawdust and palm kernel shell as possible substitutes for fine and coarse aggregate in concrete. The physical properties such as specific gravity, Bulk density, Absorption test and sieve analysis test of these local materials were examined. The materials were batched by volume for the production of concrete and ...
Get MoreTomas U. Ganiron Jr (2014), Effect of Sawdust as Fine Aggregate in Concrete Mixture for Building Construction, International Journal of Advanced Science and Technology, Vol.63, 73-82. Malay M. Patel, Ankit J. Patel, Jay H. Patel and Kushagra T. Rawal (2014), Review Paper on Partial Replacement of Concrete Ingredients, International Journal for ...
Get Moreaggregate Fine aggregate Saw dust Max size mm 20 4.75 4.75 Specific gravity 2.69 2.62 0.27 absorption 0.5 1 2 Physical properties of materials Literature Collections Study of Literature Review Properties of Material Casting Testing of Specimen Results and Discussion Conclusion
Get MoreLight weight concrete made with partial replacement of ordinary Portland cement by 20% of fly ash, fine aggregate by 10% of saw dust and coarse aggregate by 10% of coconut shell. This study is ...
Get MoreTilak, L.N., Santhosh Kumar, M.B., Manvendra, S. and Niranjan (2018) Use of Saw Dust as Fine Aggregate in Concrete Mixture. International Research Journal of Engineering and Technology (IRJET), 5, 1249-1253. has been cited by the following article:
Get MoreUtilization of five types of fine aggregate for concrete production was investigated. Normal concrete were made with different types of fine aggregate. The fine aggregate considered were sharp sand (control sample), saw-dust, crushed groundnut shell, crushed palm kernel shell and quarry dust.
Get More